Can Spray Foam Insulation Be Installed in Existing Walls?

One of the most common questions about spray foam is whether it can be added to existing walls. The answer is yes, but it is necessary to remove the drywall before the foam can be installed. Aerosol foam expands rapidly when applied to the inside of walls. To insulate existing walls, you must drill holes in the wall posts and apply spray foam to fill the walls.

Then apply the finishing touches to the walls so that they are even. Some of the benefits of insulating or re-insulating existing walls include reduced energy bills, fewer drafts from outlets, and in some cases, customers have reported a decrease in outside noise. Over time, insulation material can degrade in quality, lose its shape, or suffer damage that prevents it from effectively blocking the flow of heat. A chalk line is used to drill uniform 2 ½ inch holes through the coating to inject foam into the existing wall cavity. Under normal circumstances, insulating spray foam for walls can last more than 80 years, and closed-cell spray foam insulation has more durability than open-cell spray foam insulation. Professional installers are expensive, but taking up the challenge as a DIY project and following wall insulation installation instructions can save a lot of costs.

Aerosol foam wall insulation provides comfort and energy efficiency, and is also ideal for insulating walls in old and new homes. The wall insulation with the highest R value is aerosol foam insulation with closed-cell spray foam insulation that offers up to R7 per inch. To estimate the cost of wall insulation for 2x4 walls with a thickness of 3.5 inches, multiply the wall thickness by the wall area. In short, yes, you can install closed-cell and open-cell spray foam insulation on existing walls. To insulate an existing wall that already has fiberglass insulation, you'll first have to remove all of the fiberglass.

Paragon Protection has been one of the top aerosol-foam insulation contractors in Crystal Lake and the Chicago metropolitan area for more than 15 years. Once the foam has been injected into the cavities in the wall, teams fill the holes with a styrofoam plug and place mesh tape over it to keep it in place. The size of the treated area to be injected with foam insulation is the factor that most contributes to the cost of the project. According to The Construction of Buildings (book by Robin Barry), fibrous or cellular materials act as good insulators. Every homeowner can successfully carry out wall insulation installation by following correct guidelines.